Fiber Isolator for Broadband SLDs, 790〜890 nm, 2 W, Polarization-Independent, No Connectors

Features
・Flat Isolation over a 100 nm Wavelength Range
・Ideally Suited for Use with SLDs
・Bare Fiber Pigtails, Connectors Available on Request
・Polarization-Independent Design

Fiber isolators protect light sources from back reflections and signals that can cause instabilities and damage. They are designed to block light traveling into the source while allowing light to exit the source with minimal loss. The IO-F-SLD100-840 Polarization-Independent Broadband Fiber Isolator is specifically designed for use with superluminescent diodes (SLDs) such as our SLDF Series. Typical fiber isolators have a narrow isolation wavelength range with a peak isolation of about 33 dB. This isolator is designed for flat isolation over a broad wavelength range of 100 nm but has a lower isolation of 23 to 32 dB. This makes it an ideal choice for broad-spectrum devices like SLDs. This polarization-independent model is designed for use with CW light sources only and come with 780HP single mode fiber with bare fiber ends.